OHR page header
Oak Hills Research
            Division Of Milestone Technologies, Inc.

WM-2
QRP Wattmeter Kit

 
Click on the thumbnail images to view in full size!
 
 

This is what you start with-- the complete kit including enclosure, hardware, and a detailed instruction manual.  The WM-2 kit is not difficult, and will take the average builder approximately 4 hours to complete.
 
 
 
 

Here's the completed circuit board, before attachment of the connecting wires.  Note that the two toroids are large and have only a few turns-- no problems even for a beginner.  All component and connection points are silk-screened on the board, and the solder side is masked for your convenience.
 
 
 

Everything fits neatly inside the WM-2 case, which is pre-punched to very precise tolerances.  Alignment is simple, using a Digital Voltmeter, and there are only a few adjustments to make.  An RF source is NOT required for alignment.
 
 



Ta-daaaa!  The finished product, a laboratory quality instrument and YOU built it!


We use and recommend Kester "245" No-Clean Solder.
ohr page footer

orderohr homee-mailmorse express
Oak Hills Research
Division of Milestone Technologies, Inc.
10691 E. Bethany Drive, Suite 800, Aurora CO 80014
Phone: (303) 752-3382
Note:  We do not accept unsolicited advertisements by phone or facsimile.
Orders: 1-866-OHR KITS (1-866-647-5487)

Oak Hills Research is a division of Milestone Technologies, Inc.  All text and images in this web site are the intellectual property of Milestone Technologies. or are used with permission of the copyright holder. Please ask for permission before "borrowing" or otherwise using any images or contents from this web site.
Copyright 1996-2017, Milestone Technologies, Inc. All Rights Reserved.

revFzDD1A394